Press Center
 
Home About us Products Support Quality & Certification Career Contact us
• Power Management
    Linear Regulators
    Low Dropout Linear Regulators
    DDR Termination Regulators
    Shunt Reference Regulators
    Step Down Switching Regulators
    Switching Regulator
    Step-Up DC-DC Converter
    PWM Controller
    White LED Driver
    Supervisory Circuit
    Voltage Detection and System R
    USB Power Switch
    Power Factor Control
    Li-Battery Protection or Charg
    FET Bias Controllers
    Combo IC
    Inverting DC-DC Converter
• Amplifier / Comparator
    Audio Amplifiers
    Operational Amplifier
    Voltage Comparator
• Analog Switches
    Video Signal Switch
    Analog Multiplexers, Demultipl
• Hall ICs
• Special Application ICs
    Motor Controller IC
    Interface and Driver Circuit
    Telecommunication Circuit
    Melody IC
    Alarm /Sound Generator IC
    Remote Controller IC
    Television Circuit
    Leakage Current Detector
    Automotive IC
    A-D or D-A Converters
    Miscellaneous
    Radio and Cassette Recorder Ci
    Timer
    Mouse&Keyboard Controller
    Transient Voltage Suppressors
    Sense Monitor
    Video Filter
    ZCB snubber
• Logic
• TRANSISTORs
• MOSFETs
    JFET
    Power Mosfet
• TRIACs
• SCRs
• DIODEs
 
Home > Step Down Switching Regulators
UD05104A Datasheet
 5V, 1A, 1MHz  SYNCHRONOUS STEP-DOWN DC/DC CONVERTER

 

 

 

DESCRIPTION

                

The UTC UD05104A is a 1A high frequency synchronous
Step Down DC/DC converter using constant frequency, current
mode architecture. The device integrates main switch and
synchronous rectifier switch for high efficiency without an external
schottky diode. To maximize light load efficiency, The UTC
UD05104A draws only 30μA quiescent current to improve light
load efficiency. In shutdown, The UTC UD05104A reduces supply
current less than 1μA. The UTC UD05104A can supply 1A of load
current from 2.5V to 6.0V input voltage. The output voltage can
be regulated as low as 0.6V. The switching frequency is internally
set at 1MHz, as for operation mode: UTC UD05104A is automatic
PSM/PWM mode.
The UTC UD05104A has built-in internal Soft Start, Short
Circuit Protection and OTP functions, allowing the use of small
surface mount inductors and capacitor.

 

FEATURES

* Input Voltage Range from 2.5V to 6.0V
* +/-2% 0.6V Feedback Voltage Accuracy
* 1MHz Switching Frequency
* Continuous Output Current up to 1A
* Low Quiescent Current of 30µA
* 0.1μA Shutdown Current
* 100% Duty Cycle Operation
* Built-in 170mΩ/150mΩ Power Switch
* Internal Soft-Start
* Cycle-by-Cycle Current Limit Protection
* Over-Load and Hiccup Mode Short Circuit
* Thermal Shutdown Protection 

About us  |  Products  |  Contact us
Copyright 2011 UTC All received