Press Center
 
Home About us Products Support Quality & Certification Career Contact us
• Power Management
    Linear Regulators
    Low Dropout Linear Regulators
    DDR Termination Regulators
    Shunt Reference Regulators
    Step Down Switching Regulators
    Switching Regulator
    Step-Up DC-DC Converter
    PWM Controller
    White LED Driver
    Supervisory Circuit
    Voltage Detection and System R
    USB Power Switch
    Power Factor Control
    Li-Battery Protection or Charg
    FET Bias Controllers
    Combo IC
    Inverting DC-DC Converter
• Amplifier / Comparator
    Audio Amplifiers
    Operational Amplifier
    Voltage Comparator
• Analog Switches
    Video Signal Switch
    Analog Multiplexers, Demultipl
• Hall ICs
• Special Application ICs
    Motor Controller IC
    Interface and Driver Circuit
    Telecommunication Circuit
    Melody IC
    Alarm /Sound Generator IC
    Remote Controller IC
    Television Circuit
    Leakage Current Detector
    Automotive IC
    A-D or D-A Converters
    Miscellaneous
    Radio and Cassette Recorder Ci
    Timer
    Mouse&Keyboard Controller
    Transient Voltage Suppressors
    Sense Monitor
    Video Filter
    ZCB snubber
• Logic
• TRANSISTORs
• MOSFETs
    JFET
    Power Mosfet
• TRIACs
• SCRs
• DIODEs
 
Home > Miscellaneous
U8C3525 Datasheet
 8 BIT SERIAL-IN PARALLEL-OUT VALVE DRIVER

 

 

 

DESCRIPTION

 

The  U8C3525 is an 8-Bit Serial-In Parallel-Out driver with

Error Detection to the solenoid valve drive. The device

incorporates shift registers,  data latches, and constant current

circuitry on the silicon CMOS chip. The maximum output current

value of one channel is Approximately limited to 250mA by

Built-in constant current source.

The U8C3525 has two power supplies, VDD provides power to

Internal control and communication modules. The range of VDD is

5V to 18V. PVDD is used to absorb the inductive coil

reverse-phase current and the range of PVDD is 5V to 35V.

Its built-in open/short detection circuits help users detect Load

state of the detection channels. System retrieve the error

messages to indicate which channel has failure by serial output

data.

 

FEATURES

*VDD range: VDD  5V to18V

           PVDD 5V to 35V

*Maximum clock frequency: 1MHz

*current limit of Each channel:250mA

*Built-in open/short detection  

*Short protect

*Detecting response

*Internal reverse diode of PVDD to Absorb reverse current from coil 

About us  |  Products  |  Contact us
Copyright 2011 UTC All received