Press Center
Home About us Products Support Quality & Certification Career Contact us
• Power Management
    Linear Regulators
    Low Dropout Linear Regulators
    DDR Termination Regulators
    Shunt Reference Regulators
    Step Down Switching Regulators
    Switching Regulator
    Step-Up DC-DC Converter
    PWM Controller
    White LED Driver
    Supervisory Circuit
    Voltage Detection and System R
    USB Power Switch
    Power Factor Control
    Li-Battery Protection or Charg
    FET Bias Controllers
    Combo IC
    Inverting DC-DC Converter
• Amplifier / Comparator
    Audio Amplifiers
    Operational Amplifier
    Voltage Comparator
• Analog Switches
    Video Signal Switch
    Analog Multiplexers, Demultipl
• Hall ICs
• Special Application ICs
    Motor Controller IC
    Interface and Driver Circuit
    Telecommunication Circuit
    Melody IC
    Alarm /Sound Generator IC
    Remote Controller IC
    Television Circuit
    Leakage Current Detector
    Automotive IC
    A-D or D-A Converters
    Radio and Cassette Recorder Ci
    Mouse&Keyboard Controller
    Transient Voltage Suppressors
    Sense Monitor
    Video Filter
    ZCB snubber
• Logic
    Power Mosfet
• SCRs
Home > Interface and Driver Circuit
UTRS3085 Datasheet








The UTC UTRS3085 high-speed transceivers for RS-485/RS-422

communication contain one driver and one receiver. The device

features fail-safe circuitry, which guarantees a logic-high receiver

output when the receiver inputs are open or shorted. This means that

the receiver output will be logic high if all transmitters on a terminated

bus are disabled (high impedance). The UTC UTRS3085 offer higher

driver output slew-rate limits, allowing transmission up to 2.5Mbps.

The transceiver typically draws 375µA of supply current when

unloaded or when fully loaded with the drivers disabled.

A device has a 1/8-unit-load receiver input impedance that allows

up to 256 transceivers on the bus.




* True fail-safe receiver while maintaining EIA/TIA-485 compatibility.

* Enhanced slew-rate limiting facilitates Error-Free data transmission.

* 5.0V single power supply.

* 1µA low-current shutdown mode.

* Allow up to 256 transceivers on the Bus.

* HBM ±12kV ESD-protected.

* Driver short circuit current limit.

* Thermal shutdown for overload protection.

About us  |  Products  |  Contact us
Copyright 2011 UTC All received