Press Center
Home About us Products Support Quality & Certification Career Contact us
• Power Management
    Linear Regulators
    Low Dropout Linear Regulators
    DDR Termination Regulators
    Shunt Reference Regulators
    Step Down Switching Regulators
    Switching Regulator
    Step-Up DC-DC Converter
    PWM Controller
    White LED Driver
    Supervisory Circuit
    Voltage Detection and System R
    USB Power Switch
    Power Factor Control
    Li-Battery Protection or Charg
    FET Bias Controllers
    Combo IC
    Inverting DC-DC Converter
• Amplifier / Comparator
    Audio Amplifiers
    Operational Amplifier
    Voltage Comparator
• Analog Switches
    Video Signal Switch
    Analog Multiplexers, Demultipl
• Hall ICs
• Special Application ICs
    Motor Controller IC
    Interface and Driver Circuit
    Telecommunication Circuit
    Melody IC
    Alarm /Sound Generator IC
    Remote Controller IC
    Television Circuit
    Leakage Current Detector
    Automotive IC
    A-D or D-A Converters
    Radio and Cassette Recorder Ci
    Mouse&Keyboard Controller
    Transient Voltage Suppressors
    Sense Monitor
    Video Filter
    ZCB snubber
• Logic
    Power Mosfet
• SCRs
Home >
UHS41 Datasheet






The UTC  UHS41  is an integrated Hall effect latched sensor

designed for electronic commutation of brush-less DC motor

applications. The device includes a voltage regulator, reverse

battery protection diode, Hall sensor with dynamic offset

cancellation system, temperature  compensation circuitry, small

signal amplifier, Schmitt trigger and an open-collector output to sink

up to 25mA.  

These Hall-effect switches are monolithic integrated circuits with

tighter magnetic specifications, and are more stable with both

temperature and supply voltage changes. If a magnetic flux density

larger than threshold Bop, Output is turned on (low). The output

state is held until a magnetic flux density reversal falls below Brp,

causing Output to be turned off (high).  

Thanks to its wide operating voltage range and extended choice

of temperature range, it is quite suitable for  use in DC motor

applications. It also can be used for Automotive, Consumer and

Industrial, Solid-state switch, Speed measurement, Revolution

counting, Angular position detection and Proximity detection.  




* wide operating voltage range4.5V~24V 

* Wide ambient temperature range: –40°~150°C  

* Bipolar technology  

* Open-collector 25mA output  

* Reverse battery protection  

* Solid-state reliability  

* Resistant to physical stress  

* Activate with small, commercially available permanent magnets

About us  |  Products  |  Contact us
Copyright 2011 UTC All received