Press Center
 
Home About us Products Support Quality & Certification Career Contact us
• Power Management
    Linear Regulators
    Low Dropout Linear Regulators
    DDR Termination Regulators
    Shunt Reference Regulators
    Step Down Switching Regulators
    Switching Regulator
    Step-Up DC-DC Converter
    PWM Controller
    White LED Driver
    Supervisory Circuit
    Voltage Detection and System R
    USB Power Switch
    Power Factor Control
    Li-Battery Protection or Charg
    FET Bias Controllers
    Combo IC
    Inverting DC-DC Converter
• Amplifier / Comparator
    Audio Amplifiers
    Operational Amplifier
    Voltage Comparator
• Analog Switches
    Video Signal Switch
    Analog Multiplexers, Demultipl
• Hall ICs
• Special Application ICs
    Motor Controller IC
    Interface and Driver Circuit
    Telecommunication Circuit
    Melody IC
    Alarm /Sound Generator IC
    Remote Controller IC
    Television Circuit
    Leakage Current Detector
    Automotive IC
    A-D or D-A Converters
    Miscellaneous
    Radio and Cassette Recorder Ci
    Timer
    Mouse&Keyboard Controller
    Transient Voltage Suppressors
    Sense Monitor
    Video Filter
    ZCB snubber
• Logic
• TRANSISTORs
• MOSFETs
    JFET
    Power Mosfet
• TRIACs
• SCRs
• DIODEs
 
Home >
L1131A Datasheet

LOW NOISE 150mA LDO REGULATOR
 
 
 
DESCRIPTION
 
The UTC L1131A is a COMS positive linear regulator. One of
it’s feature is the very low quiescent current typical as low as 10μA
and its dropout voltage is extremely low with 150mA output current,
and high ripple rejection. Each of these ICs consists of a voltage
reference unit, an error amplifier, resistor-net for voltage setting, a
short current limit circuit, a chip enable circuit, and so on.
These ICs perform with low dropout voltage and the chip-enable
function. The supply current at no load of this IC is only 10μA, and
the line transient response and the load transient response of the
UTC L1131A Series are excellent, thus these ICs are very suitable
for the power supply for hand-held communication equipment.
The output voltage of these ICs is fixed with high accuracy.
Since the packages for these ICs are SOT-23-5 therefore high
density mounting of the ICs on boards is possible.
 
 
 
FEATURES
 
 
* Low supply current Typ. 10μA
* Standby mode Typ. 0.1μA
* Output Voltage Range 1.2V~5.0V
* Excellent line regulation Typ. 0.02%/V
* Built-in fold back protection circuit
* Ceramic capacitors are recommended to be used with this IC
CIN=COUT=1μF
About us  |  Products  |  Contact us
Copyright 2011 UTC All received