Press Center
 
Home About us Products Support Quality & Certification Career Contact us
• Power Management
    Linear Regulators
    Low Dropout Linear Regulators
    DDR Termination Regulators
    Shunt Reference Regulators
    Step Down Switching Regulators
    Switching Regulator
    Step-Up DC-DC Converter
    PWM Controller
    White LED Driver
    Supervisory Circuit
    Voltage Detection and System R
    USB Power Switch
    Power Factor Control
    Li-Battery Protection or Charg
    FET Bias Controllers
    Combo IC
    Inverting DC-DC Converter
• Amplifier / Comparator
    Audio Amplifiers
    Operational Amplifier
    Voltage Comparator
• Analog Switches
    Video Signal Switch
    Analog Multiplexers, Demultipl
• Hall ICs
• Special Application ICs
    Motor Controller IC
    Interface and Driver Circuit
    Telecommunication Circuit
    Melody IC
    Alarm /Sound Generator IC
    Remote Controller IC
    Television Circuit
    Leakage Current Detector
    Automotive IC
    A-D or D-A Converters
    Miscellaneous
    Radio and Cassette Recorder Ci
    Timer
    Mouse&Keyboard Controller
    Transient Voltage Suppressors
    Sense Monitor
    Video Filter
    ZCB snubber
• Logic
• TRANSISTORs
• MOSFETs
    JFET
    Power Mosfet
• TRIACs
• SCRs
• DIODEs
 
Home >
PA4894 Datasheet
 

1.8 WATT DIFFERENTIAL AUDIO POWER AMPLIFIER
WITH
SELECTABLE SHUTDOWN
 


 
DESCRIPTION
 
The UTC PA4894 is a differential audio power amplifier,
characterized by its selectable shutdown mode for flexible operation.
Shutdown may be enabled by either logic high or low depending on
the voltage applied on the SD MODE pin and the shutdown mode
features low power consumption.
This device provides customers perfect sound performance by
its high quality audio, moreover, less external components and lower
power dissipation are required.
Operating with a 5.5V power supply, the UTC PA4894 is
capable of driving an 8.0Ω load at a continuous average output of
1.8W under a 10% THD+N. If it works with a 5.0V voltage under the
same load conditions, 1.0W power will be delivered and the
distortion will be less than 0.01%.
The UTC PA4894 incorporates protection circuit to avoid the
click and pop noise, which may occur during the transition state
between turn-on and turn-off.
The UTC PA4894 can be directly connected to a battery without
an LDO since it has perfect PSRR. The UTC PA4894 can be
configured externally with resistors to provide a controlled gain and
with bypass capacitor to provide a controlled turn-on time for more
flexibility.
The UTC PA4894 is suitable for applications, such as portable
electronic devices, PDAs and mobile phones.
About us  |  Products  |  Contact us
Copyright 2011 UTC All received