Press Center
 
Home About us Products Support Quality & Certification Career Contact us
• Power Management
    Linear Regulators
    Low Dropout Linear Regulators
    DDR Termination Regulators
    Shunt Reference Regulators
    Step Down Switching Regulators
    Switching Regulator
    Step-Up DC-DC Converter
    PWM Controller
    White LED Driver
    Supervisory Circuit
    Voltage Detection and System R
    USB Power Switch
    Power Factor Control
    Li-Battery Protection or Charg
    FET Bias Controllers
    Combo IC
    Inverting DC-DC Converter
• Amplifier / Comparator
    Audio Amplifiers
    Operational Amplifier
    Voltage Comparator
• Analog Switches
    Video Signal Switch
    Analog Multiplexers, Demultipl
• Hall ICs
• Special Application ICs
    Motor Controller IC
    Interface and Driver Circuit
    Telecommunication Circuit
    Melody IC
    Alarm /Sound Generator IC
    Remote Controller IC
    Television Circuit
    Leakage Current Detector
    Automotive IC
    A-D or D-A Converters
    Miscellaneous
    Radio and Cassette Recorder Ci
    Timer
    Mouse&Keyboard Controller
    Transient Voltage Suppressors
    Sense Monitor
    Video Filter
    ZCB snubber
• Logic
• TRANSISTORs
• MOSFETs
    JFET
    Power Mosfet
• TRIACs
• SCRs
• DIODEs
 
Home >
L1923 Datasheet

500mA HIGH PSRR LDO REGULATORS 


 
DESCRIPTION
 
The UTC L1923 is a low supply current, low dropout linear regulator.
It is operating at 2.5V - 5.5V. The supply current is as low as 55μAin
the no–load condition. In the shutdown mode, the maximum supply current is less than 1μA. 
A built-in over-temperature protection circuit is designed to protect
the device from being damaged by thermal overload. The over-current protection limit is set at 800mA (TYP.)
The UTC L1923 can be operated on the following two modes. When
the SET pin is connected to ground, the output of L1923 is a pre-set
value and the external components are not needed to decide the
output voltage. When an output other than the preset value is needed,
two external resistors should be used as voltage dividers and then the
output voltage is decided by the resistor ratio.
The UTC L1923 is generally used in notebook computers, cellular
phones, PDAs, digital still camera and video recorders and other hand-held devices.
 


 
FEATURES
 
* Low No-Load Supply Current: 90µA  
* Guaranteed 500mA Output Current
* Dropout Voltage is 200mV @ 250mA Load
*OTP(Over-Temperature Protection) and Short-Circuit Protection
* Two Modes Of Operation:
Fixed Mode3.3V3.5V3.9V
Adjustable Mode: 1.25V - 5.5V
* Maximum Supply Current In Shutdown Mode is Less than 1µA
* Low Output Noise at 238µVRMS
* Stability with Lost Cost Ceramic Capacitors
About us  |  Products  |  Contact us
Copyright 2011 UTC All received